Home > Not Working > Car Remote Key Not Working

Car Remote Key Not Working

Contents

The car still locks but sometimes within minutes, sometimes within hours the remote beeps twice and says the doors have been opened (the doors don't unlock though). Why? Last month my battery died for reasons unknown, took a charge and has held it for a month, however the remote start has not worked since the battery was disconnected. They don't even make a noise. have a peek here

Only driver door and right rear have trouble. Read more How to Buy Fuel Treatments Adding a fuel additive to your gas tank when you fill up is one way to clean vital engine parts of deposits, improve the I refused to pay that insane dealer replacement key price. I would just like to know your professional insight on this issue and how this can be fixed.

Car Remote Key Not Working

Another question my father's car is an 07 chevy malibu would i be able to use the same kit in my 06 chevy colorado since he doesn't care to use it? could it be a bad switch? 0 | Reply - Share Hide Replies ∧Carl2 years 3 months agoHi, my passenger door locks/unlocks both doors but my driver side door works independently Any suggestions? Upgrade the Remote or Key If none of these strategies succeeds, try a new remote.

I would go back to the shop that installed it and asked them to take a look. Do it yourself save $$$$! - Duration: 3:33. P:s. Key Fob Problems About Press Copyright Creators Advertise Developers +YouTube Terms Privacy Policy & Safety Send feedback Try something new!

I bought a car 2nd hand from a Ford dealership and the car has a remote starter that was not installed by the dealership that sold me the car so they Thank you Reply Mitchell Schaffer says June 18, 2013 at 2:20 pm Colette, First of all, sorry for the delay. All it took to fix was a few tiny drops of solder (and a soldering iron, of course), and when he put it back together, everything worked perfectly again. An error occurred.

when i push the unlock button the interior lights come on and the dashboard lights come on just like it would if the doors unlocked. Keyless Entry Remote Not Working After Battery Replacement I figured that the door actuators only pertain to each door. So before you go out and buy one, try this quick fix that worked for Redditor diggalator, and cost absolutely nothing. Get our best tips delivered straight to your inbox with YP's weekly newsletter!

Car Remote Stopped Working

When an engine is warm it starts a little quicker and requires less crank time then when the engine is cold. It won't lock, but I don't have to crawl over seats to get it open. Car Remote Key Not Working Sorry about that. Car Remote Not Working After Battery Change What I found on these remotes is the micro switch had not completely become unseated from the board.

Try spray lubricantIf the lock is still  sticking, then get a can of multi-purpose spray lubricant and use the supplied tube to spray inside the lock mechanism. navigate here All rights reserved. | Terms & Conditions | Privacy Policy Connect with us on Facebook Featured Story: How to Fix Car Dents: 8 Easy Ways to Remove Dents Yourself Without Ruining Reply linda says April 5, 2012 at 9:59 am Just bought car (no warrenty) the blue light was solid not flashing for few months for last few weeks been flashing constantly, You should receive your first newsletter within the next week. Car Key Not Working In Ignition

Some final advice: When you are choosing a remote car starter and installer, do not trust your vehicle to the lowest bidder and be sure to get it installed where you bought it! SOLUTION, fix: Transmission & Received wireless reliability, depends on the outside ANTENNA CONNECTION. Basically, he pried the remote apart and took out the board, noticing that the 'Lock' and 'Unlock' buttons had come loose. Check This Out I you have 12 volts and a ground then the solenoid is defective. 0 | Reply - Share Hide Replies ∧Rich2 years 4 months agoCarl - Love your insight!

ffs #15 12-23-2011, 04:02 PM gearhead Registered User Join Date: Mar 2008 Location: port coquitlam canada Posts: 684 Rep Power: 56 Had mine die as well. Toyota Keyless Entry Not Working Most of our remote starters go into valet mode by pressing a combination of two buttons on the remote control for 1/2 second. I tried a few variations ...

Thanks 0 | Reply - Share Hide Replies ∧Wes2 years 6 months agoI have a Pontic 2002 Montana it to only locks with the remote?

Reply rage says May 7, 2016 at 12:37 pm Had same issue with remote starter only going into ACC. I got in and put my key in the ignition and it wouldn't start at all. You issue sound like it could be something as simple as a blown fuse… It is also possible that the remote control has lost programming.. What To Do When Your Car Remote Doesn't Work Master of 2 Basset Hounds, 1 Beagle and 2 cats....

AL AK AZ AR CA CO CT DE DC FL GA HI ID IL IN IA KS KY LA ME MD MA MI MN MS MO MT NE NV NH NJ Reply Glenn says February 13, 2012 at 5:11 pm I have an aftermarket remote in my 2004 Ford Explorer sport trac xlt. The remote batteries should be ok, as they do flicker blue. http://pagesetter.net/not-working/sky-remote-not-working-with-tv.html I'd guess that it is a defect in the remote, but I would contact the manufacturer directly.

At the beginning, the central locking system was going AWOL and would click hen I turned a corner or something like that but since changing the battery in the remote this Reply Shawna says December 7, 2011 at 6:24 pm My remote car starter stopped working. Symptoms: Pressing Start results in several flashes of the parking lights but no start. It's also the case that each time he actuates the system, there is sound in the other lock solenoids, but it gets weaker with each actuation.

Can you please give your expert advise. So i had to leave the vehicle there. Remote starters usually have some type of non-volatile memory to retain things like programming features and remote control codes. To fix the problem, grab a soldering iron and some tweezers.

The calipers are what presses the brake pads against the rotors. Reply Denny says January 29, 2013 at 7:36 pm Hi there I have a compustar 901ss 2 way car starter. Key fobs that don't permit entry can be a major hassle for drivers, but fortunately, there are some DIY fixes that don't require an ounce of dealership assistance. It likely has lost programming.