Home > Saab 9 > Saab 9-5 Air Conditioning Problems

Saab 9-5 Air Conditioning Problems


The SAI works with the Ox sensor at start up for only the first couple of minutes.I removed this device (in front of the battery - round, black, pump looking device The DICE controls the input from the sending unit and if the DICE has a failure the heating or AC system wont recognize signals from the control unit which is the So I do in fact have an issue with the left blend door. A couple different types of heater convtol valves, the one on top from SAAB and the one below is for a BMW #3 Heater Control Valve AKA Heater bypass valve, or weblink

Repair parts are to tolerances of 0.025mm and pre-indexed to within 0.5º thereby eliminating stress to the blend door. The SAI unit's motor will probably be pretty well melted from the short and may have to be replaced to pass smog.This should fix your problem and has nothing to do Email Address: Vehicle Info. I'm wondering if there is a heater door sticking?

Saab 9-5 Air Conditioning Problems

Browse By Make Audi Parts BMW Parts Mercedes Benz Parts Mini Cooper Parts Porsche Parts SAAB Parts Volvo Parts VW Parts My Account Order History Return History My Projects Account Settings Two, the valve or pump that sends hot coolant to the heater core is not engaged and is suspectIf both hoses are hot and you have no heat it has to Powered by vBulletin Version 4.2.3 Copyright © 2016 vBulletin Solutions, Inc. Mostrar más Cargando...

The air conditioner works fine. MODERATOR --Need help with anything? Wait until the system has stabilized (approx. 30 seconds). 16. Saab Climate Control Problems On V6 models air can get trapped in the system and that will cause issues.

A few days ago she said she hit a bump and then had heat. Saab 9-5 Blend Door Repair This is very hazardous in Minnesota - tonight I had no defrost after a trip to church! Click on my name! 0 · Share on Facebook saabeson Posts: 1 August 2008 Hello all, new to this. There Is A Cable That Is Located On The Passenger Side That Is Hanging.

Solution: cut the red wire the slightest bit shorter and crimp another connector on there, boom done. Saab 9-5 Code 08 But mine didn't snap off like most. Not too expensive, I had the same problem. Look for any bleed valve or screw near the highest point.

Saab 9-5 Blend Door Repair

What brand blower motor was installed? I saw those online , maybe ebay, just didn't know for sure that they were what I may need. 11-30-2013, 09:11 AM #17 Saab95Aero Avid TSL User Saab 9-5 Air Conditioning Problems Does anyone know how to fix that problem ? Saab 9-5 Acc Codes Press in the metal shaft so it is pressed into the lever on the passenger side.

Can't really say how accessible your heater core area is on that car. http://pagesetter.net/saab-9/2003-saab-9-3-ac-fuse.html Now I am more confident to dig in. Take off the higher hose and run the engine with full coolant. Purchase items here. 2001 Saab 9 5 Heater Problems

Contact Us - SaabLink.net - Archive - Privacy Statement - Top Powered by vBulletin Copyright ©2000 - 2016, vBulletin Solutions, Inc. I get a 3 on the left and 13 on the right when I run the ACC diagnostic. Note Error code B2409 (code 21) is not related. check over here Its kinda bulky, but it fit easily in the fuse compartment.

Initial estimation would point to loose wiring, corrosion, or a bad ground. Saab 9-5 No Heat Totally different subject but has anyone had a 9-5 that the power seat moves weird? Valentine says September 13, 2016 at 3:37 pm Thanks for getting back to me Adam.

Duchess DIY 96.676 visualizaciones 15:01 How to change your cabin air filter on a SAAB 9-5 - Duración: 6:07.

If someone was sitting in the back seat they would be uncomfortably hot. I have to climb under the dash and see what makes it have heat and see if I can at least lock it in the heat position for right now, I User Name Remember Me? Saab 9-5 Stepper Motor Choose left or right Left, or port side Right or starboard side Blend door issues usually present with a code 08 on the left side, or code 11 on the right,

No codes popping up and otherwise no problems. Manual calibration must be performed if the stepping motor is replaced, removed or if the position of the flaps is changed. Iniciar sesión 13 Cargando... http://pagesetter.net/saab-9/saab-9-3-wiper-linkage.html That will hopefully help solve coolant flow problems through your heating system.

I had NO heat and after this fix.. I checked the code and it comes up as a "0", so I don't think it's the blend doors.Any suggestions? 0 · Share on Facebook mastertater Posts: 4 September 2010 Ok, I've seen 'em as low as $30, and as much as $99. Not possible to regulate temperature on either left or right-hand side in front?

Note: latest part number is 5336664 now priced over $460.00

79 71 864 (CA: 30509025) cable tie (x2)


This service information applies if one of the damper shafts is broken.

What do you think? It's not what you want to hear, but it will take some time with a multimeter to track this down, most likely. Use your hand to check that air is flowing from the panel vent. 17.